![]() ![]() a/arch/arm/mach-kirkwood/sheevaplug-setup. Search for gear like this Watch Watch this gear and we'll notify you if it becomes available again. Change to build_dir/linux-kirkwood/linux-2.6.30.10 and apply the following patch: Electric Guitars Hollow Body Phred Brett's Gear Locker Decatur, GA, United States Phred Dockstar 2020 Blue/ Natural Used Mint 1,400 + 105 Shipping It looks like that piece of gear is gone. by Christian Franke At the time they became available I was quite eager to obtain a Seagate DockStar as it provided a platform quite similar to that of a Sheeva Plug, but at a much lower price.(This step isn't required, but I recommend it for easier recovery from bad flash writes below.) Use "make kernel_menuconfig" to add built-in SCSI disk, USB EHCI, USB storage, and ext2 filesystem support.Ä£. Installing Debian GNU/Linux in the NAND flash of a DockStar Debian GNU/Linux on (not next to) a DockStar. Also select built-in luci and ntpclient packages. Add squashfs in the target images section. Use "make menuconfig" to configure the build system for a kirkwood target. Iâm selling my Phred Dockstar that I used for 3 years with my Phish tribute band, itâs in beautiful condition and comes with a hard case. You need to build your own OpenWrt kernel and root filesystem image, because the Marvell Kirkwood target currently supports only the Sheevaplug, which has a different NAND flash layout. See this page for the serial pinout (and how to open the case) and this page for a picture of where to find the connector.Ä¢. Open the case and install a serial cable. No one has tried to restore the factory firmware yet, so we don't know whether that's possible. WARNING: this approach requires you to open the case and install a serial cable, and completely replaces the factory-installed software with OpenWrt. Update: I've consolidated this HOWTO and the following one into a single guide to installing OpenWrt on the Dockstar. This post describes how to install an OpenWrt kernel and rootfs on the internal NAND flash of the Seagate Dockstar so that it will boot into OpenWrt at power-on, with no USB storage device required. ![]()
0 Comments
Leave a Reply. |